@Phil SheltonYou would need a civil engineer to provide a drawing to get submitted to zoning and get a permit if it passes zoning is most common This also depends on the road - if it’s a state road forget it as it will take a year to get approved and cost a fortune - if it’s a local road process not as cumbersome but don’t expect this to happen quicklyIn some instances you may have to prepare sight distances etc to make sure it’s safe to add a curb cut

They then use their roll formers to form and cut the roof sheet steel and to also form the beams, rafters and purloins. 

These things going to court you have to Steel Man the argument and if you can do that with a good base for your side being in the right/wining the argument then you may be able to win in court.

That would mark the third rate cut in a row, a full percentage point lower since they started cutting in September.

Or all steel or aluminum?

Quote from @Lauren Cutchen: Is there anything you can do about the scratch marks made all over a stainless steel stove? 

I believe that the Federal Reserve is going to cut rates by 25-50 bps at it's September meeting (no emergency cut), but that 30-year fixed rate mortgage rates will rise to upper 6s low 7s around the same time, and Commercial borrowing rates, including for multifamily, will increase as well. 

We Normally put steel posts nearby so no one runs into them.In the third picture one unit is just in front of the picture, then a second unit is at the far end on a post.These can be set off by deep fog, rain or sleet. 

Build with steel. 

I found a win - win situation for the corporate owner, the rail road land owner, and the community who were plagued by the vagrants steeling and causing mischief.