What are the best places to look for these? Other than here on Bigger Pockets. Right now, I am going bank by bank on their website. This cannot be the most efficient way, right? Is it worth it to pay for a site like R...
Hi all,I recently bought my first property and I have had it up for rent for 1 week listed at $1250.The link to my property can be found here - http://www.realtor.com/realestateandhomes-detail/9...I am thinking about ...
Is anyone here investing in the pittsburgh area? I am interested in purchasing REO property in the area, and im trying to figure out where to start.
How does one go about getting the jump on one of these kinds of dea...
Hey all! I am in the Cleveland, Ohio area and new to the RE game. I have done a decent amount of independent reading and learning but that only goes so far. I am looking to meet some experienced investors in the area ...
I am selling a house to a relative. There was a reinspection that was needed to be done by the appraiser over small items such as water heater straps, and a CO2 detector. These items were corrected over 3 weeks ago an...
Hello, BP!My name is Roy. I accidentally posted a forum recently without a proper introduction, so my apology.I am an entry level electrical/power engineer in Raleigh while attending NCSU to finish up my EE degree. I...
Alright I'm fairly new to this site my question is...
When some one sends you a PM note, how do I respond to this with another PM note? I see the Post Reply button, but if I respond this way will that make it public...
You may have seen this before, but it's worth going around again...
This video clearly shows that George Bush warned
Congress starting in 2001, that this economic crisis was
coming, if something was not done. But C...
How does one arrange financing for buying foreclosed/pre-foreclosure properties that are being auctioned? I always assumed you needed cash on hand, but can they be bought with some kind of mortgage?
Could a draftsman use their own designs for a spec build in Missouri as long as they get stamped by a structural engineer first? Would it make the cost/process any easier that way since it’s following a set blueprint ...