UPDATE:Had the owner of the company come through on Wednesday.Master plumber with over 40 years experience.Very nice and professional.While were there fixed too emergencies.One the p trap was leaking under the kitchen sink and water was going everywhere.Another unit water was coming down from the upstairs through the kitchen.That ended up being the metal line going into toilet tank.Someone wrench tightened the line going into the tank when they were only supposed to hand tighten.This caused a crack in the plastic seal and the water then started pouring out.The plumbers fixed it.When he came out on Wednesday he looked at 2 units.He said to do it right he needs to have 2 of his plumbers out there and go unit by unit.They will check all fixtures kitchen,bath,washer,etc. and do compression test.

Boxes will run about $.98 to $2.00 depending on if you get the plastic or metal boxes and how many and where you buy them.

Most urban areas require trash be stored in plastic or metal cans with lids.

Hey everyone,Currently I work for a plastic display company and have developed carpal tunnel and tendinitis in both hands due to continuous repetitive motion.

The valve is in a plastic bay above and behind the washer, the drain hose also goes into the drain through the bay.

From what I have found is that it is cheaper than copper and more expensive than plastic.

His opinion was that the pipe itself was fine, but the problems occurred with the plastic fittings that were sometimes used. 

After this was done we put down 14mm plastic under the house as a moisture barrier.We dug a French drain around the front of the house back to the creek to help with any moisture issues under the house.While we were under the house we also replaced all the plumbing with brand new pipes.Both bathrooms have been completely renovated with the master getting a full custom tile shower and the other bathroom getting a soaker tub with custom tile surround.

you obviously have some siding & J channel missing.the latter is cheap as is plastic brick molding to replace the wood rotI would then use the plastic molding product 3-4 inches to frame them & secure the siding for now.here is a pic of a window my guy re-framed with plastic brick molding (bottom piece is not yet installed) & a sliding door with plastic wood (3/4 x 3inch) look planks ready to go to better interface with the siding fit. 

The picture is of one in my house, but the one available is still in the plastic.