WHat are these locations?

I’ve seen cases where multiple tenants in a household had prior evictions from different addresses, taking turns as the primary leaseholder to avoid detection.

. Move outlet from behind range to more optimal location Install GFCI outlets within 4 feet of each other along counter space.o At Least two dedicated lines – all on GFCI breakers and at least one GFCI outletper circuit Install dedicated electrical circuits as follows:o Microwave: Dedicated 20-amp circuit (12/2 NM wire with a ground).o Garbage disposal: Dedicated 15-amp circuit (14/2 NM cable with a ground).o Refrigerator: Dedicated 20-amp circuit (12/2 NM wire).o Gas range: Dedicated 120-volt, 20-amp circuit (12/2 NM cable).o Dishwasher: Dedicated 15-amp circuit (14/2 NM cable with a ground).Bathroom Demolish existing bathroom elements. Install new cement board on floor and tub surround.o Seal with cement tape and red guard Install new fan, light, mirror, vanity, and replace toilet lid. Remove old tile and install new tile. Install new hardware and replace any old drain and supply lines. Install niche and tile from bathtub to ceiling. Install new bathtub and GFCI outlet. Light and fan on same switch Install all necessary plumbingLiving Room Install sliding door board trim. Install spot lights. Install 3-way switches in the hallway, living area and staircase (where marked). Install new air vent covers.Hallway/Staircase Install 10-inch LED light. 3-way switch (one near kitchen other near bedroom) Place laminate with Metal bullnose Install spotlights over staircase and one at landing at the bottomo lights on 3 way switchesBalcony Paint railing. Replace lightBedrooms Install spotlights in bedroom (up to four per bedroom). Install new fan. Spackle, sand, and paint. Paint closets and shelving, ensuring proper installation of shelves. Install spotlight in walk-in closet.Outside Paint stair railing. Install or repair 2 doorbells. Install or repair 2 exterior lights.Materials Included Cement/hardy board, drywall material. Granite slab for countertop and bar. Kitchen sink (D shape). Setting materials (thinset, grout, drywall tape, red guard, etc.). Baseboards, door, and balcony trim. Plumbing materials (excluding fixtures). Fastener screws.Total labor cost: $13,000

(key piece of the story) And where are you/the property located?

Your location, your list, your approach, market conditions, time of year etc.The only thing I can tell you with 100% certainty is you'll need to SMS a lot more people than you will need to cold call.

If you did a cost segregation study on the property in the past, you may have to recapture the depreciation taken in the past.capital gain tax rates are 0, 15 or 20%There is also a potential 3.8% Net Investment Income Tax.Also, don't forget state income taxes depending on what state the property is located or your state of residency.Best of luck!

*Another Exciting Development in Charlotte*The Iron District is set to break ground next year (address 905 w morehead st.)The Iron District's strategic location offers easy connections to Uptown, South End, Wesley Heights, Freedom Drive, Camp Greene, I-77, I-277, and Charlotte Douglas International Airport.

We are in the Burlington area, where are you located?

There is no penalty for the tenant to end the lease at any time with a 30 day notice"...And the reason I did this is because it is very important to me, with small town circumstances and dynamics for my family in the town the rental is located in, that the tenant not be disrespectful or unfair in any way. 

I would recommend that you don't ignore it; repair the drywall, monitor it and see if the drywall cracks in the same locations again.