Chris Adams
My 22 duplex lot deal - $1MM in debt - purchased with no money down.
27 December 2017 | 137 replies
When I started the first building it was damn near impossible to find a framer.
Zain B.
Raising the Roof and Addition
24 January 2018 | 5 replies
Out of my experience, it depends on your framer.
Adam Fiore
Is my Fear of leveraging justified
30 December 2019 | 25 replies
CAN your framer run 2 or 3 crews same with your sider or painter etc.
Meryl McElwain
Ask me anything about...Construction.
11 January 2022 | 115 replies
Framers do not buy lumber, tyvek or tape.
Greg P.
How to get into Development Projects?
15 September 2012 | 21 replies
We have tile guys, framers, foundation , etc.
Omer Bar
Where can i see houses floor plans
24 December 2021 | 6 replies
It seems to me that sometimes there were modifiactions made on site, perhaps a few bucks to the framers, so they would create a bump out for the kitchen.Even today, when you build new construction, the city requires 5 full sets of paper prints to review and approve; they get rubber stamped and I believe archived, but I don't know how long they keep them.
Michael Doherty
Do lawn-care/snow removal myself or hire out?
17 February 2019 | 71 replies
I know lots of guys in the industry, particularity dirt guys, framers, form guys, the ones whose jobs stop when it snows, up in the North East who make a killing.
Michael Herr
No thinset under cement board
4 February 2022 | 61 replies
And if the framers used a level and did the job right then you'll find the job of tiling that much easier
Rich Weese
Anyone really interested in construction??
4 November 2018 | 116 replies
For the excavator and framer, this is a long time to wait, however these subs are guaranteed additional homes to build one right after another.
Eric C.
Bowed Wall on New Construction Property
9 September 2020 | 3 replies
Due to timing constraints on the tenant side, we decided to wait until after the new year to get it fixed.Turns out that the bowed wall was caused by the water supply line coming in too close to the wall so the framer had to push out the frame as much as he could to avoid the supply line.