Hello. Looking for some advice on the railing on my balcony. I don't see a lot of damage, but there was a missing cap on one of the posts, 1.25 inch diameter.  I also don't see that there is a drainage point, not unti...

Getting ready to paint the interior walls of a new flip project and I want to use a sprayer.. Using 1 color only.. Not spraying the ceiling or trim. What do I need to make sure I mask off? Windows/Doors.. What about t...

Do you think that patio homes are a worthwhile investment?

I'm looking at a foreclosed patio home for $150K. However, the comps in that subdivision aren't any higher than $150K. Are these better as rental properties?...

We are considering making an offer on a bank owned property in Michigan, but there are potential issues. The lot is approximately 8 inches short of the minimum lot width requirements. In addition, the edge of the ho...

Rehab newbie here. We started demo on one unit in our new fourplex today. The kitchen alone had 4 different types of cabinets, 2 mismatched counters (that were connected) and once we tore up the first layer of floorin...

I have read posts discussing who does the snow removal but didn't come across one regarding how often. Question is, if there was a snow storm that lasted let's say 8 hrs and accumulated10 inches, do you clean up...

Going to look at a house with a bridge plank foundation that has started to cave. Are these even legal. Maybe grandfathered. Any ideas on how to proceed.

Hello I am under contract to purchase a bank owned single family home in Connecticut. As I was doing my final inspection I realized there is no insulation in the walls in about 60 percent of the house ( the exterior ...

We are about to close on a property.  Just got the survey back, the casita in the backyard encroaches on another property by a whopping 18 inches. The casita looks like it has been there at least two decades.Is this a...

What software are flippers/re-modelers using to generate simple construction plans?
In the past I've either hand sketched or done simple layouts with Excel tools. 
Autocad/Revit will certainly get the job done, but ...